JVC VN-C30U - Manual (Page 21)

21
[Alarm Configuration] window
This window sets the action to be performed when an alarm signal is input.
[On/Off] Check [On] when using the corresponding alarm input (1 or 2)
and check [Off] when not using it.
[Settings] An alarm input enables the camera movement to one of the
positions stored in the position memory and an alarm signal
output.
• [Go to a Preset Position]
Select one of the positions 1 to 10, which have been set in
the VN-C30U [Position Memory Configuration] window. When
an alarm is input, the camera will move to the specified
position.
• [Alarm Out]
When “Yes” is selected, the alarm output outputs the signal
set in [Alarm Out] below in the case of an alarm input.
• [FTP]
When “1” or a larger value is selected, the FTP client function
will be enabled for a certain period according to the current
FTP settings, even if the function is disabled by a setting. (To
make this possible, the FTP settings should be set to enable
FTP in advance.)
Alarm 1 or 2
03.10.17, 11:20 AM Page 21