JBL gto506c - Manual (Page 3)

Figure 5. Mounting the tweeter using
the I-Mount flush-mounting kit.
Figure 6. Aiming the tweeter at a
desired listening position.
Figure 7. Mounting the tweeter using
the I-Mount surface-mounting kit.
Big Lug =
Small Lug =
To AMPLIFIER
SPEAKER OUTPUTS
To WOOFER
To TWEETER
Red
Blk
INSTALLATION CONNECTIONS
1) push in
2) turn
3)
4)
–
+
red
blk
1. Slide screw up or
down to adjust
tweeter angle.
4. Securely tighten
the large hand nut.
2. Tighten nut and
washer to lock
angle settings.
3. Rotate to aim
angled tweeter
toward listener.
1
2
–
+
red
blk
Open the crossover housing by firmly squeezing the sides
of the top half and lifting it away from the bottom. Using
screws or a wire tie, mount the crossover using the holes
provided. Observing proper polarity, connect the speakers
and amplifier as shown in Figures 8A and 8B. Replace the
cover when you are finished making the connections and
adjustments (see following section).
Figure 8A. Wiring connections on the crossover network
(shown with cover on).
Figure 8B. Locating wiring connections on the GTO506c
woofer. Other woofers are wired similarly.