Jet Tools M-708448 - Manual (Page 8)

8
Assembly
1. Remove all contents from the shipping
container.
2. Clean all rust protected surfaces with a mild
solvent. Do not use paint or lacquer thinner,
gasoline,
or mineral spirits; these will
damage painted surfaces.
3. Attach the four rubber pads (A, Fig. 1) to the
bottoms of the side panels with four 5/16” x
5/8” Screws, four 5/16” flat washers and four
5/16” hex nuts (B, Fig. 1).
The hardware
can be found in the bag with the rubber
pads.
4. Attach the side panels (C, Fig. 1) to the front
panel (D, Fig. 1) with four 5/16” x 5/8” hex
cap bolts, eight 5/16” flat washers, four 5/16”
lock washers, and four 5/16” hex nuts (E,
Fig. 1). Hand tighten the hardware at this
point.
Note: Assemble the stand up side down to
make sure that the tops of the panels are
flush.
5. Mount the shelf (F, Fig. 1) to the inside of
the stand with two M5x10 pan head screws
and two M5 lock washers (G, Fig. 1).
6. Finish stand assembly by attaching rear
panel to side panels with four 5/16” x 5/8”
hex cap bolts, eight 5/16” flat washers, four
5/16” lock washers, and four 5/16” hex nuts.
7. Make sure stand is sitting evenly on a level
surface before tightening hardware.

WARNING
Main unit is heavy! Use great care and
adequate resources when lifting the unit up
onto the stand!
Failure to comply may cause serious injury
and/or damage to the sander and/or
property!
8. With the aid of another person, carefully lift
the main unit out of the shipping box, and
up onto the stand. Line up threaded holes
in sander base with holes in stand.
9. Through the door in the cabinet attach main
unit to stand with two 5/16” x 1-1/4” hex cap
bolts, two 5/16” lock washers and two 5/16”
flat washers.