Timer programming, Code, Access g-code screen – JVC HR-J255EA User Manual
Page 20: Enter g-code number, Access g-code program screen, Set tape speed, Timer recording (cont.)
20
EN
1
2
3
4
0
6
7
8
5
9
1
4
3
2
G-CODE
1 2 3 4 5 6 7 8
[0 – 9]
=
[CANCEL] : DELETE
[PROG] : EXIT
ACCESS G-CODE SCREEN
1
Press PROG..
ENTER G-CODE NUMBER
2
Press the NUMBER keys to
enter the G-
CODE
number
of a programme you wish
to record.
● If you make a mistake,
press CANCEL and input
the correct number.
ACCESS G-CODE
PROGRAM SCREEN
3
Press OK, and the G-
CODE
Program screen appears (if
you’re just starting out,
“P1” appears).
IMPORTANT
Make sure the channel position number you wish
to record is displayed; if not, see "G-
CODE
Setup" on
page 18 and set the Guide Program number for that
G-
CODE
number correctly.
● If the number you entered is invalid, "ERROR" appears
on the screen and "Err" appears on the display panel.
Press CANCEL and input a valid G-
CODE
number.
● If the "GUIDE PROG SET" screen appears, see
"ATTENTION – Regarding Guide Program Number
Set" on page 21.
SET TAPE SPEED
4
Press SP/LP (
) to set the tape speed.
– P1 –
G-CODE
123456789
START
STOP
21:00
=
22:00
SP
DATE
TV PROG
25.12
1
: OK
G-
CODE
Timer
Programming
Before performing G-
CODE
Timer Programming:
● Be sure to read "G-
CODE
Setup" (
੬
pg. 18).
● Insert a cassette with the safety tab in place. The recorder
will come on automatically.
● Turn on the TV and select the VIDEO channel (or AV mode).
With G-
CODE
, timer programming is greatly simplified because
each TV programme has a corresponding code number which
your recorder is able to recognise.
TIMER RECORDING (cont.)
G-CODE
[0 – 9]
=
[+/–] : EXPRESS PROGRAMING
[PROG] : EXIT
NUMBER
CANCEL
PROG.
OK
SP/LP