John Deere ET-3403-J - Manual (Page 12)

12 10-Inch Compound Miter Saw Operator's Manual
Preparation
PREPARATION:
Make the following preparations before operating the power tool:
1.
Installation:
Attach the power tool to a level, horizontal work bench in
accordance with Fig. 3. Select 5/16" (8 mm) diameter
bolts suitable in length for the thickness of the work bench.
For example, use 2" (50 mm) or larger bolts for 1"
(25 mm) thick work bench. The holder attached to the rear of
the base helps stabilize the power tool.
2. Releasing the locking pin:
When the power tool is prepared for shipping, its main parts
are secured by a locking pin. Move the handle
(see Fig. 4) slightly so that the locking pin can be disengaged.
During transport, lock the locking pin into the gear case.
NOTE: Lowering the handle (See Fig. 1) slightly will enable you to
disengage the locking pin easily and safely. The lock
position of the locking pin is for carrying and storage only.
3. Installing the dust bag, holder and vises:
Attach the dust bag, holder, and vises as indicated in Fig. 1.
(Fig. 3)
(Fig. 4)