Jensen XRS Series - Manual (Page 5)

Basic Installation Steps
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
: Remove existing speaker.
: Position new speaker and align with existing
mounting holes.
: Attach the positive (+) and negative (-) speaker
terminals (see FIGURE 2). Be sure to observe
proper polarity when connecting the wires.
: If not using factory grilles, attach grille.
: Mount speaker (using factory hardware when
possible).
: Reconnect negative battery terminal.
INSTALLATION
FIGURE 2 - CONNECTING SPEAKER WIRES
(+) (-)
FIGURE 3 - REAR DECK INSTALLATION FIGURE 1 - DOOR PANEL INSTALLATION
Grille Door Panel Speaker
Push terminal UP to insert speaker wire.
3