JVC SR-VD400E - Manual (Page 45)

EN
45
VCR
TV
CABLE
/DBS
2
[TV/VCR]
[TV VOL
+/–]
[ENTER]
[ ]
4
3
- 3
3
- 2
4
3
- 1,3
4
POWER AUX
JKL
STOP
When programmed (set) with a manufacturer’s (brand’s)
code, this Remote can perform some of the remote control
functions of the listed TVs. You can control a JVC TV without
setting a brand code.
1 Turn on the TV
Turn on the TV using the [POWER] button on the
TV or its Remote.
2 Set remote operation mode
Set the [VCR/TV/CABLE/DBS] selector to [TV].
3 Set TV brand code
Follow the example shown below.
1 Press and hold [POWER].
2 Press the ‘Number’ keys to enter your TV’s
brand code by referring to the table below.
3 Press [STOP ( 7 )], and release [POWER].
● Once you have set the Remote to operate the
TV, you do not have to set it until you replace
the batteries from the Remote.
● JVC and PANASONIC have two codes. If the TV
does not function with one code, try entering
the other.
4 Operate TV
Press one of the following buttons: [POWER],
[TV/VCR], [TV/VCR CH +/–], [
] (TV
Muting), [TV VOL +/–], and ‘Number’ keys.
● For some brands, you must press [ENTER] after
having pressed the ‘Number’ keys to enter a
channel number.
● To operate the VCR, set the [VCR/TV/CABLE/
DBS] selector back to [VCR].
NOTES:
● Depending on the type of TV, some or all functions cannot be
operated using this Remote.
● It‘s impossible to control a TV that does not have a remote
sensor.
BRAND CODE
01, 03
10
02
03
04, 11
05
06
07
12
13
13
08
09
TV Brand
Setting
(Ex.) To set Remote to RCA 05:
Press in succession
Hold
down
Release
TV BRAND NAME
JVC
HITACHI
MAGNAVOX
MITSUBISHI
PANASONIC
RCA
SHARP
SONY
SAMSUNG
SANYO
SEARS
TOSHIBA
ZENITH
MULTI-BRAND REMOTE CONTROL
‘Number’ keys