JVC UX-NB7DAB - Manual (Page 12)

9
Basic Tuner Operations
To
Press
On the System On the remote
Select a band
Each time you press the button, the band
changes as follows:
DAB
FM AM
The selected band and frequency appear on
the main display.
• When an FM stereo broadcast with
suffi cient signal strength is tuned in, the ST
(stereo) indicator lights on the display.
When you change the source to DAB for the fi rst time after plugging in the
AC power cord, the System automatically scans the DAB bands for available
ensembles. (See page10.)
• For general information of DAB, see “What is DAB system?” on page 10.
Change the FM reception mode
(When a stereo broadcast is
hard to receive or noisy)
—
Press to improve reception.
The MONO indicator lights up on the display.
Reception will improve though the stereo
eff ect is lost.
To restore the stereo eff ect, press again.
For FM/AM
Select a frequency
or or
Press and hold for more than 2 seconds.
The System starts searching for stations and
stops when a station of suffi
cient signal
strength is tuned in.
• Press during searching to stop.
• Press repeatedly to change the frequency
step by step.
Tune in to a preset station — or
Press to select a preset number for the preset
station.
• For presetting stations, see page 12.
For DAB
Select an ensemble
or or
Press and hold for more than 2 seconds.
• You can select from the ensembles
scanned by the ensemble scanning.
Select a service (either primary
or secondary)
Press briefl y while tuning in to an ensemble.
Tune in to a preset service
— or
Press briefl y to select a preset number for the
preset service.
• For presetting services, see page 12.
Tune in to all ensembles
Press and hold for more than 2 seconds.
The frequency changes every second
through all ensembles regardless of the
signal status.
• Press and hold the button until the desired
ensemble is reached.
Listening to the Radio
EN_01_20_UX-NB7DAB[B]ff.indd 9 EN_01_20_UX-NB7DAB[B]ff.indd 9 06.7.6 11:27:14 AM 06.7.6 11:27:14 AM