John Mills PRO CERAMIC STRAIGHTENERS - Manual (Page 8)

8
Instructions for Use
1. Fully unwind the mains cable.
2. Connect the appliance just before it is required for use (30-40
seconds), as the plates heat up very fast. Maximum temperature
(205ºC) is reached after 240 seconds.
3. Only connect the appliance to a properly installed mains socket
– 220-240 Volts- 50Hz.
4. For straightening the hair, take a section no more than 2 to 3 inches
wide and about 1⁄2 inch thick. Place the hair between the 2 flat plates
and close them tight. Slide the plates as close as possible to the
scalp without touching it. (DO NOT TOUCH THE SCALP)
5. Hair straightening spray or serum can be used to enhance your hairs
shine.
6. Hold the plates tight (by pressing the handles together). Hold for a
2-3 seconds and slide the unit away from the head towards the ends
of the hair.
7. DO NOT HOLD THE HAIR BETWEEN THE PLATES FOR ANY MORE
THAN 2-3 SECONDS.
8. When one section of hair has been treated, move to another.
9. Please unplug after use and allow to cool before storing.
Cleaning and Maintenance
• The appliance must be switched off and unplugged from the
electricity supply before cleaning.
• Do not touch the ceramic plates for at least 30 minutes after turning
off. Wipe with a damp cloth to clean the ceramic plates.
• Let the appliance cool down before touching or cleaning the body.
• Clean the body with a damp cloth.
• Do not use harsh detergents, abrasives, solvents or cleaners. Never
immerse in water to clean.
• Do not repair or replace the mains cable on the appliance yourself–
always use an authorised representative or qualified electrician.