JABSCO 29200 SERIES 29060-0000 - Manual (Page 2)

Adaptor
Installation Instructions
assembly (key 2) using your mark, so that the
discharge flange is on the same side of the
motor as the entry of red and black wires,
before using the 2 longer screws (key 13) to
secure the waste pump assembly to the motor
assembly.
CAUTION: Do NOT apply any
sealing compounds or lubricants
4. FITTING ADAPTED CONVERSION
You are now ready to convert your standard or
large bowl manual toilet.
Follow the installation instructions provided
with your Jabsco Conversion.
Note that your Adaptor Kit is supplied with its
own matching black rubber base gasket with
holes for 3 screws that should be used instaed
of the base gasket ( key 12) supplied with the
conversion which has holes for 4 screws.
NOTE : Replace the standard macerator housing
with the adaptor before you start to install the
conversion on your toilet.
1. PREPARATION
Your Jabsco Adaptor is designed to be installed by
the user and no special tools are needed.
2. REMOVING EXISTING MACERATOR
HOUSING
Keep all screws, which will be re-used to fit the
Adaptor.
Make a mark across the joint between the motor
assembly (key 2) and the waste pump body (key
5) that will enable you to realign them later.
Remove the 4 long screws (key 13) that secure
the macerator housing (key 15) to the waste
pump body (key 5) and notice that the screws
are of 2 different lengths.
Pull the macerator housing (key 15) off the waste
pump body (key 5), remove and keep the O ring
(key14).
Remove the exposed paper gasket that you can
see (key 7) and throw it away.
3. FITTING ADAPTOR
Fit one of the 2 new paper gaskets suppied
(key 7).
Replace the O ring (key 14) in position in the
groove on the waste pump body (key 5).
Push on the Adaptor.
Using the shorter 2 of the 4 screws (key 13)
secure the Adaptor to the waste pump body
(key 5).
Align the waste pump assembly to the motor
•
•
•
•
•
•
•
•
•
•
•
•
Warranty: All products of the company are sold and all services of the company are offered subject to the company’s warranty and terms and conditions of sale, copies of which will be furnished upon request.
©Copyright 1999 ITT Industries 43001-0528
Jabsco
ITT Industries
Jabsco, 20 Icon, Foothill Ranch, CA 92610-3000
Tel : +1 949 859 4945 Fax : +1 949 859 1153
Jabsco, Bingley Road, Hoddesdon, Hertfordshire, EN11 0BU
Tel : +44 (0) 1992 450 145 Fax : +44 (0) 1992 467 132
Fluid Products Canada, 55 Royal Road, Guelph, Ontario N1H 1T1
Tel : +1 519 821 1900 Fax : +1 519 821 5316
NHK Jabsco Co Ltd, 3-21-10, Shin - Yokohama, Kohoku-ku, Yokohama 222
Tel : +81 (0) 45 475 8906 Fax : +81 (0) 45 475 8908
Jabsco GmbH , Oststraße 28, 22844 Norderstedt
Tel : +49 (0) 40 53 53 73 0 Fax : +49 (0) 40 53 53 73 11
USA
UK
CANADA
JAPAN
GERMANY
www.jabsco.com