JVC HR-DD845EK - Manual (Page 24)

24
Video Plus+
Timer
Recording
ACCESS TIMER PROGRAMMING
SCREEN
1
Press PROG
The front display panel looks like this:
ENTER PLUSCODE NUMBER
2
Press the NUMBER keys to
enter the PlusCode
number of a programme
you wish to record.
● If you make a mistake,
press CANCEL to
backspace and then
input the correct number.
The PlusCode number you
enter appears on the front
display panel:
The display panel can show only a 4-digit number.
ACCESS VIDEO PLUS+ PROGRAM
SCREEN
3
Press OK, and the Video
Plus+ Program screen
appears (if you’re just
starting out, “P1” appears).
The display panel shows
the programme start time.
Pressing PROG CHECK
changes the display to the
programme stop time, then
the date and preset
position.
IMPORTANT
Be sure to confirm the setting of PDC recording.
● If " ON" is displayed on the screen or " " is lit
on the display panel, PDC is set to ON.
● If " OFF" is displayed on the screen or " " is
not lit on the display panel, PDC is set to OFF.
To change the setting, press : PDC (NUMBER key
"7").
੬
"PDC Recording" in the left column.
● Make sure the preset position number you wish to
record is displayed; if not, see "Video Plus+ Setup" on
page 10 and set the Guide Program number for that
PlusCode number correctly.
● If the number you entered is invalid, "ERROR"
appears on the screen and "Err" appears on the
display panel. Press CANCEL to backspace and input
a valid PlusCode number.
● If "ERROR=GUIDE PROG" appears on the screen, see
"ATTENTION – Regarding Guide Program Number
Set" on page 25.
TIMER RECORDING
Before performing Video Plus+ Timer Recording:
● Be sure to read "Video Plus+ Setup" ( ੬
pg. 10).
● Insert a cassette with the safety tab in place. The recorder
will come on automatically.
● Turn on the TV and select the VIDEO channel (or AV mode).
1 2
4 5
3
6
8
0
7 9
2
4
1
3 OK
2
3
PROG
1
TIMER PROGRAMMING
[0 – 9] : VIDEO PLUS+
[+/–] : EXPRESS PROGRAMING
[MENU] : MAIN MENU
V I D E O P L U S +
1 2 3 4 5 6 7 8
[0 – 9] =
[CANCEL] : DELETE
[MENU] : EXIT
– P1 –
VIDEO PLUS+ 123456789
START STOP
21:00 = 22:00
SP OFF
DATE TV PROG
25.12 1
BBC 1
: OK
CANCEL
: PDC
NUMBER
SP
Now available from some TV stations, PDC (Programme
Delivery Control) is a service designed to assure safe,
accurate timer recording. With this system, special code
signals are transmitted together with the audio/video
signals. These code signals control your video recorder and
have precedence over advertised times you preset in the
timer. This means that your recorder will start and stop
recording when the preset TV programmes actually start
and end — even if the broadcast time of a preset TV
programme is changed.
NOTES:
● PDC recording is also possible when a satellite receiver
or a cable system is connected to AV2 IN on your
recorder.
● PDC recording is also possible via the AV1 IN/OUT
connector and the front panel connectors.
PDC Recording
PROG CHECK