JVC KY-F75 - Manual (Page 15)

E11
Ⅵ When the motorized lens is used
AC ADAPTER AA-P700
ON
OFF
POWER
AA-P700
AC
[IEEE1394]
[LENS]
[REMOTE]
[DC IN]
AC Adapter
Connect to power supply
(page. 16)
IEEE1394 cable
Supplied clamp filter
CD-ROM supplied with KY-F75:
Exclusive application software
[KY-LINK] and drivers for KA-
FW4IU
Control
cable
Compatible
zoom lens
Fujinon S16
× 7.3DA-DSD
Flash
Trigger switch
KA-FW4IU (separately sold)
PC
Lens remote control
Fujinon RMD-10
● Control of the motorized lens is not possible when the [IEEE1394] connector is used to supply
the power.
When the motorized lens is used, the separately sold AC Adapter AA-P700 should be used to
supply the power to the camera.
Connect the [DC IN] connector on the KY-F75 to the AA-P700 using the DC power cable.
Attach the clamp filter supplied with the KY-F75 to the DC power cable.
● Connect the camera cable from the lens to the [LENS] connector on the KY-F75.
Connect the zoom and focus control cable from the lens to the lens remote control.
● The lens control possible with this unit is only control of the iris. Control of zoom and focus
requires a separately sold lens remote control unit.
Ⅵ Precautions for connection
● Do not turn the AC adapter’s power switch ON or OFF, or connect or disconnect the IEEE1394
cable, while the application software [KY-LINK] is running.
● When connecting 2 or more cameras to one computer, multiple images can-
not be shown at the same time.
● When using a microscope adapter, use a 1/2” C-mount adapter fitting the
microscope to be used. To reduce the risk of the adapter causing damage to
the camera, use an adapter that is 4 mm shorter than the lens mount surface.
4 mm or
shorter