JVC CA-D352TR - Manual (Page 31)

27
English
Using the Timer
The timers let you control listening and recording functions automatically.
Use the Remote Control to set the clock and timers.
Setting the Clock
The timers depend on the clock: the clock must be right for the timers to work as you expect.
You can set the clock whether the Unit is on or off.
Note that the clock must be set, otherwise the timers cannot be set.
1. Press the SHIFT button.
2. Press the 1 CLOCK button.
The CLOCK indicator on the display lights up and the clock time blinks.
3. Press the SELECT 5 + or 4 – button to set the time.
Pressing the 5 + button increases the time and pressing 4 – decreases the time. Pressing the button
continuously advances or decreases the time in 10 minute intervals.
4. Press the 8 SET button.
The clock stops blinking, and the clock timer starts from 0 seconds.
CAUTION: If there is a power failure, the clock loses its setting. The
display shows “0:00”, and the clock must be reset.
When the System is being used, the display shows other items as well.
However, we have only shown the items described in this section.
kHz
MHz
CONT.
ALL PRGM REC
A.BASS EX S.MODE
SLEEP MONO ST CLOCK
RANDOM TA NEWS INFO EON
Timer indicator
Clock, timer-on time etc.
Display
SHIFT
1
CLOCK
4 5
– SELECT +
8
SET
1 CLOCK
2 TIMER
4 – SELECT 5 +
8 SET SHIFT
This illustration shows
the Remote Control for
CA-D352TR. The
Remote Control for
CA-D302T does not
print the PTY/EON
and DISPLAY MODE
labels.
CA-D302/352TR[E]/EN 98.2.13, 9:57 PM 27