Tree felling technique, Safety instructions – Jonsered CS2163 User Manual

Page 19

Advertising
background image

English

– 19

SAFETY INSTRUCTIONS

The log is supported at one end. There is a high risk that it
will split.

Start by cutting from below (about 1/3 of the way through).

Finish by cutting from above so that the two cuts meet.

The log is supported at both ends. There is a high risk that
the chain will jam.

Start by cutting from above (about 1/3 of the way through).

Finish by cutting from below so that the two cuts meet.

Limbing

When limbing thick branches you should use the same
approach as for cutting.
Cut difficult branches piece by piece.

Tree felling technique

Safe distance

The safe distance between a tree that is to be felled and
anyone else working nearby is at least 21/2 tree lengths.
Make sure that no-one else is in this ”risk zone” before or
during felling.

Felling direction

The aim is to fell the tree in a position where you can limb and
cross-cut the log as easily as possible. You want it to fall on
ground where you can stand and move about safely. The main
point to avoid is letting the tree fall onto another tree. See
instructions under the heading Freeing a tree that has fallen
badly.

Once you have decided which way you want the tree to fall
you must judge which way the tree would fall naturally.

Several factors affect this:

Lean of the tree

Bend

Wind direction

Arrangement of branches

Weight of snow

You may find you are forced to let the tree fall in its natural
direction because it is impossible or dangerous to try to make
it fall in the direction you first intended.

Another very important factor, which does not affect the felling
direction but does affect your safety, is to make sure the tree
has no damaged or dead branches that might break off and
hit you during felling.

!

WARNING! It takes a lot of experience to fell
a tree. Inexperienced users of chain saws
should not fell trees. Do not attempt any task
that you feel unsure of!

1

2

3

!

WARNING! During critical felling operations,
hearing protectors should be lifted
immediately when sawing is completed so
that sounds and warning signals can be
heard.

Advertising