Joovy Caboose Ultralight 45X Series - Manual (Page 6)

Caboose Ultralight Instruction Manual
Installing and Operating the Canopy
• To attach the canopy, position the canopy on the stroller with the visor extension
forward.
• Line up the male fittings on the canopy with the female fittings near the center of the
stroller and push downward until the fittings snap into place. See Figure 7. Pull upward on
the canopy sides to be sure both are snapped securely in place.
• To open the canopy, pull forward on the front edge of the canopy while holding the back
edge in place. Once the canopy is fully opened, push down on BOTH side hinges to lock
it in the open position.
• The canopy and visor can be adjusted into several positions ranging from fully closed to
fully extended, or any position in between.
• The visor can be opened (or closed) by pulling (or pushing) it from under the canopy.
• The canopy will ratchet forward or backward to block the sun. Pull forward on the front of
the canopy frame tube to rotate it forward. Pull backward on the rear frame tube to rotate
it backward. See Figure 8.
• To close the canopy, unlock the side hinges and pull the front edge toward the rear of the
stroller until folded. See Figure 9.
• To remove the canopy, press the lock button on the side of each of the male fittings while
pulling upward on the canopy frame. See Figure 10.
Page 5
Front Wheel Locks
The front wheels can be either in swivel
mode or locked mode.
• To put the front wheels in their locked
mode, first rotate each wheel set so that
the wheels are pointed straight ahead.
• Pull up on the lever to engage the small
tab on the lever with the slot in the plastic
frame sleeve. The lever can be either
facing forward or rearward to lock the
wheels. See Figure 6.
• To unlock the wheels and put them into
swivel mode, push down on the lever to
disengage the tab from the slot.
Figure 6