JVC CA-MXGB6 - Manual (Page 12)

9
Common Operations
2
Press
¢ or 4 to adjust
the hour, then press SET/
DISPLAY.
The minute digits start flashing on
the display.
• If you want to correct the hour after pressing SET/
DISPLAY, press CANCEL/DEMO. The hour
digits start flashing again.
3
Press
¢ or 4 to adjust
the minute, then press SET/
DISPLAY.
To check the clock time
Press and hold SET/DISPLAY for more than
2 seconds while playing any source.
• To return to the source indication, press
SET/DISPLAY.
While the time indication appears on the display
If you press a button or turn a control, the time indication returns to
the source indication.
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until “CLOCK” is selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
If there is a power failure
The clock loses the setting and is reset to “– – : – –.” You need to set
the clock again.
ON TIME
(Daily Timer)
DAILY
Canceled ON TIME
(Recording Timer)
CLOCK
REC
Turning On or Off the Power
To turn on the unit, press STANDBY/ON
so that the standby lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON again so that the
standby lamp lights up.
A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “– – : – –” soon, while the tuner preset stations
(see page 12) will be erased in a few days.
Saving the Power Consumption While on
Standby—ECO Mode
You can save the power consumption while the unit is turned
off (on standby).
To activate the ECO mode, press ECO
while the unit is turned off (on standby).
The display illumination (including the
display demonstration) disappears.
To deactivate the ECO mode, press ECO again.
The display illumination appears.
• Turning on the unit also deactivates the ECO mode.
About the ECO mode
While the ECO mode is activated, the display demonstration is
canceled temporarily.
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit. You can set the clock whether the unit is on or
off.
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
MXGB6&5[B]_09-10.p65 04.1.21, 5:32 PM 9