JVC DX-T66 - Manual (Page 264)

7
English ¤ To adjust the voltage selector
Preparing the remote control
• Dispose of batteries in the proper manner, according to
federal, state, and local regulations.
Canceling the Demonstration
To start the demonstration, select DEMO START.
Changing the Color System and
Scanning Mode
You can select the video output to match it to the color
system of your TV (NTSC or PAL).
• If you connect a progressive TV through the
COMPONENT jacks, you can enjoy a high quality picture
from the built-in DVD player by selecting progressive
scanning mode.
• You can change the setting only while the disc playback is
stopped.
1
Enter the color system setting mode.
2
Select the color system and scanning mode.
3
Store the setting.
Use a screwdriver to rotate the
voltage selector so that the voltage
mark is pointing at the same voltage
as where you are plugging in the unit.
(See also the back cover page.)
DO NOT plug in before setting the voltage
selector and all connection procedures are
completed.
When using the remote
control,
point the top of the
remote control toward the
remote sensor as directly as
possible. If you operate it
from a diagonal position,
the operating range (approx.
5 m) may be shorter.
DO NOT recharge, short, disassemble, heat
the battery or dispose of it in a fire.
Voltage mark
R6(SUM-3)/AA(15F)
NTSC / PAL NTSC or PAL Interlaced scanning.
For a conventional PAL or NTSC TV.
NTSC / PAL
PROG NTSC or PAL Progressive scanning.
For a progressive NTSC or PAL TV.
Main Unit
ONLY
2 sec.
DEMO OFF
DEMO START
Remote
ONLY
INFO
SCAN MODE
VFP
2 sec.
PAL
PAL PROG NTSC PROG
NTSC
SET
DX-T77&99[UW].book Page 7 Monday, March 27, 2006 4:11 PM