JVC HR-J259EE - Manual (Page 37)

EN
37
%
SELECT STATION NAME
CHARACTER
1
Press PUSH JOG until
the first letter of the station
name begins blinking.
ENTER NEW CHARACTER
2
Press PUSH JOG %fi to cycle through the characters
(A–Z, 0–9, –, * , +, (space) ) and stop when the
desired character is indicated, then press PUSH JOG
to enter. Enter the remaining characters the same way
(maximum of 4).
After entering all characters, press OK.
● The Channel List screen appears.
● If you make a mistake, press PUSH JOG until the
incorrect character begins blinking. Then enter the
correct character by pressing PUSH JOG
%fi.
CLOSE CHANNEL LIST
SCREEN
3
Press MENU.
[ %
%
Set Stations (B)
Perform steps 1 and 2 of "Storing Channels Manually" on
page 34 to access the Channel List screen and then perform
step 1 and 2 of "Set Stations (A)" on the left before continuing.
Set station names other than the ones registered in your recorder.
TV System Selection - When
you see the picture but hear
no audio
Perform steps 1 and 2 of "Storing Channels Manually" on
page 34 to access the Channel List screen before continuing.
SELECT CHANNEL
POSITION
1
Press PUSH JOG
%fi until the channel position you
want to change its TV system begins blinking, then
press OK. The Manual Channel Set screen appears.
SELECT TV SYSTEM
2
Press PUSH JOG until TV system setting (D/K or B/G)
begins blinking and then press PUSH JOG
%fi to select
the appropriate TV system. Refer to the table on page
34 also.
RETURN TO CHANNEL LIST
SCREEN
3
Press OK.
● The Channel List screen appears.
● Repeat steps 1 through 3 as necessary.
CLOSE CHANNEL LIST
SCREEN
4
Press MENU.
%
TV
PR CH ID FINE SYSTEM
06 CH45 ARD +/– D/K
[ 5∞] : A-Z, 0-9
[ ] : CURSOR +=
: OK
[MENU] : EXIT
∞ ∞