GE 97986 GE Wired Optical Mouse for PCs - Manual (Page 3)

3
CONNECTING YOUR MOUSE
1. Turn off the power to your computer. (You must
Shut Down and Turn Off your computer before
connecting or disconnecting any PS/2 device.
Failure to do so could damage your computer.)
2. Disconnect the existing mouse.
3. Connect your new GE Optical Mouse to the
round mouse PS2 port on your computer.
(Usually this port is green.)
4. Turn on your computer and start your Operating
System.
5. Move the mouse to ensure there is a good
connection.
If your mouse does not work properly, please
check that all connections are secure and the
cable is free of twists. After following these steps,
please contact Jasco product support at
www.jascoproducts