Jensen CD-540 - Manual (Page 9)

CD PLAYER OPERATION
Note:
This CD player will not only play commercial CDs, but also self-compiled CD-R/RW discs.
Do not attempt to play CD-ROM, CDI, VCD, DVD or computer CDs.
Notes on CD-R/RW Discs
• Because of non-standardized format definition/production of CD-R/RW, playback quality &
performance are not guaranteed.
• Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions
such as PC performance, writing software, media ability, etc.
• Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a
malfunction.
1. Open the CD Door (# 11) by pressing the Open CD Door Button (# 2).
2.
Carefully place an audio CD with its label side upward in the CD compartment and close
the CD Door by pressing on the CD Door (# 11) where PUSH CLOSE is indicated.
3. Set the Function Selector (# 27) to the "CD" position. The POWER Indicator (# 22)
will light. The LED Display (# 23) will briefly display flashing “- -”and then the total
number of tracks on the CD will appear in the LED Display (# 23) after a few
seconds.
4. Press the CD PLPA/PAUSE Button (#12). The Play/Program Indicator (# 25)
will light and the CD will start playing from the first track.
5. Adjust the Volume Control (# 1) to obtain the desired sound level from the Built-in
Speakers.
6. To suspend playing, press the CD PLAY/PAUSE Button (#12) and the track
No. of the playback track will flash.
To resume playing, press the CD PLAY/PAUSE Button (# 12) again.
7. You can choose to play your favorite track directly by pressing either the Skip Forward
Button (# 19) or Skip Backward Button (# 20). The LED Display (# 23) will indicate
the correct track number selected.
8. To locate a particular passage within a track, keep the CD Search Forward Button (# 19)
or CD Search Backward Button (# 20) depressed until it is found.
9. To repeat a particular track, press the CD REPEAT Button (#13) until the CD
Repeat 1/All Indicator (# 24) flashes.
10. To repeat the entire CD ,
, , press the CD Repeat Button (#13) until the CD Repeat
1/All Indicator (# 24) lights steadily.
11. To stop playing, press the CD STOP
■
Button (#14).
12. When you wish to turn off the CD Player, set the Function Selector (# 27) to the "TAPE"
position. The POWER Indicator (# 22) will go off.
CD PROGRAMMED PLAY
This function allows the tracks to be played in a programmed sequence.
NOTE: Program can only be set in STOP mode.
1.
In CD stop mode, press the PROGRAM Button (# 18) once. Program No. “01”
will appear and blink in the LED Display (#13).
2. Press the CD Skip Forward Button (# 19) or CD Skip Backward
Button (# 20) to select the song to be programmed. For example track 5 is
selected.
- EN 9 -