JVC XL-MV757TN - Manual (Page 10)

Page 6
XL-MV777GD/XL-MV757TN
LVT0194-001B [U, US]
Preparation for playing
Turn on the television set, amplifier or receiver to which the player
is connected. Then set the channel and modes properly to accept
the player’s output signal.
BASIC OPERATIONS
Now you can play a
variety of discs!!
Overview of the two play modes
The player has two play modes for Video CD and SVCD discs. These
are selected by the PLAY MODE switch on the left side of the front
panel.
Display window
The display window indicates many aspects of control and operation
status.
Shows the disc number being played.
Shows mainly the total number of tracks and the track number being
played.
Mainly shows the cumulative time (minutes and seconds) of the
track when the player is playing. It also shows the total time of the
disc for about ten seconds after the player stops playback, or
finishes reading the disc information when a disc has been inserted.
Shows the type of disc being played.
Each indicator in this area lights when the corresponding function
is activated.
NORMAL: Allows use of the Playback Control (PBC) function.
PBC OFF: Inhibits the PBC function.
It only affects Video CD and SVCD discs with PBC function.
Triple disc tray usage
Up to three discs can be loaded in the player. You may insert a disc into
any of the disc trays 1 through 3.
If you want to play only a specified disc, press the corresponding CD
1, 2 or 3 button located to the right of the
0 (OPEN/CLOSE) button.
When three discs are inserted, basic order of playing is as follows.
•
Pressing CD 1: CD 1 → CD 2 → CD 3 → STOP
• Pressing CD 2: CD 2 → CD 3 → CD 1 → STOP
• Pressing CD 3: CD 3 → CD 1 → CD 2 → STOP
NORMAL PBC OFF
CD 3
CD 2
CD 1
1
2
3
4
5
Press the / button on the front panel or the VCD / (TV / ) button
on remote control. The STANDBY indicator goes out.
The display window shows the initial information as shown below.
ON OFF
POWER
CAUTION
Set the sound volume of the television set, amplifier or receiver
to which the player is connected to a reasonable level before
starting playback.
Press the POWER ON/OFF button.
or
VCD
TV
/
/
(Remote control)
CD
CD
CD CD 3
PLAY & EXCHANGE
4
1 5 2 3
STANDBY /ON
/