Jensen Phase Linear BT1613 - Manual (Page 21)

BT1613
19
Reconnecting
Automatic Re-connection
The unit has a built-in Auto Re-connection
function. When a paired phone is in range, the
head unit will automatically reconnect with the
mobile phone when the ignition key is turned on
(only if the mobile phone was previously paired
with the head unit).
Manual Re-connection
Under the following conditions, you may need
to reconnect manually:
• If the mobile phone is out of range (more
than 2 meters from the head unit).
• If the connection is lost and while talking
on the phone (or there is an incoming call)
more than 2 meters from the head unit.
• When doing an audio transfer from the
phone back to the head unit.
To manually reconnect with the paired phone,
perform the following steps:
1. Press and hold the DISP button (9) to
access the MENU.
2. Press the DISP button again to select the
“RE-CON” option.
•
The LCD displays “WAIT >>>” during
the re-connection period.
• If the re-connection is successful, the
LCD displays “OK” and returns to the
previous mode.
• If the re-connection fails, the LCD
displays “FAIL” and automatically
returns to the previous mode.
Disconnecting the Phone from
the Head Unit
To manually disconnect with the paired phone,
perform the following steps:
1. Press and hold the DISP button (9) to
access the MENU.
2. Press the DISP button again to select the
“RE-CON” option.
3. Turn the AUDIO CONTROL (3) to select
“DIS-CON”.
•
The LCD displays “WAIT >>>” during
the disconnection period.
• If the disconnection is successful, the
LCD Display displays “OK” and
returns to the previous mode.
Managing Incoming Calls
When there is an incoming call, the LCD will
display the phone number. If the incoming call
cannot be displayed, the LCD will display
“PHONE IN”.
NOTE: When a call comes in during stand-
by mode (ignition on/power off), the head
unit will turn on automatically so you can
accept/reject the call.
NOTE: When a call comes in during talking
mode, the OPEN/EJECT button (12)
becomes deactivated.
Answering an Incoming Call
To answer the incoming call, press the AUDIO
CONTROL button (4).
NOTE: During an incoming call, the audio
output is muted and a ringtone is played. CD
play is paused.
Use the AUDIO CONTROL (3) to adjust the
volume during your phone conversation. During
an active call, the LCD will display “TALK #.##”,
with the number signs representing elapsed call
time.
To end the conversation, press the BAND
button (5).
Rejecting an Incoming Call
Press the BAND button (5) to reject an
incoming call.