Jet Tools JWP-208 - Manual (Page 22)

22
Problem Possible Cause Solution
Motor failure.
Miswiring of the unit.
On/off switch failure.
is correct, you have a motor problem.
If electrical motor is suspect, you have two
options: Have a qualified electrician test the
motor for function or remove the motor and
take it to a quality electric motor repair shop
and have it tested.
Double check to confirm all electrical
connections are correct and properly tight. The
electrical connections other than the motor are
pre-assembled and tested at the factory.
Therefore, the motor connections should be
double checked as the highest probability for
error, If problems persist, double check the
factory wiring.
If the on/off switch is suspect you have two
options: Have a qualified electrician test the
switch for function, or purchase a new on/off
switch and establish if that was the problem on
changeout.
Optional Accessories
(for the JWP-208 Planer)
Stock No Description
708808 Knives, Single Sided (set of 4)
708583 Low Speed Gear Kit
Ordering Replacement Parts
To order parts or reach our service department, call 1-800-274-6848 between 7:30am and 5:31pm (CST),
Monday through Friday. Having the Model Number and Serial Number of your machine available when
you call will allow us to serve you quickly and accurately.
Parts
Head Assembly – Parts List
Index Part No. Description Size Qty
1 ............... JWP208-001 ............Head Casting ....................................................... .................................... 1
2 ............... TS-1525021 .............Set Screw............................................................. M10 x 12 ..................... 8
3 ............... JWP208-003 ............Cutterhead ........................................................... .................................... 1
4 ............... 6292620 ...................Spring................................................................... .................................... 8
5 ............... 708808 .....................Knife ..................................................................... .................................... 4
6 ............... JWP208-006 ............Knife Gib .............................................................. .................................... 4
7 ............... 6292623 ...................Hex Cap Bolt ........................................................ M8 x 10 ..................... 24
8 ............... JWP208-008 ............Knife Gauge Bar .................................................. .................................... 1
9 ............... JWP208-009 ............Knife Gauge ......................................................... .................................... 2
10 ............. JWP208-010 ............Washer................................................................. 3/8 ............................... 2
11 ............. JWP208-011 ............Nut........................................................................ M10 ............................. 2