Jensen Tools Mobile Receiver - Manual (Page 15)

CDX6311
11
CD PLAYER OPERATION
Insert and Eject CD
Press the eject button (22) and let the motorized front panel swing-down to display the CD slot.
Insert a CD label side up. After inserting a CD, the front panel will close automatically. To stop
CD play and eject the CD, press the eject button. After ejecting the CD, the unit will close
automatically after 10 seconds or you can close the front panel immediately by pressing the
eject button again.
NOTE: The unit is designed for play of standard 5” (12 cm.) compact discs only. Do not
attempt to use 3” (8 cm.) CD singles in this unit, either with or without an adaptor, as
damage to the player and/or the disc may occur. Such damage will not be covered by
the warranty on this product.
Pause
Press the pause button (12) to suspend disc play. Press the pause button again to resume disc
play.
Track Select
Press the UP TUNING (10) or DOWN TUNING (11) button for less than one second to advance
to the next track on the CD. The selected track number will appear on the display. Press and
hold the UP TUNING (10) or DOWN TUNING (11) button for more than one second to fast
forward or fast reverse through the disc. CD play starts when the button is released.
Intro Scan (SCN)
During disc play, press SCN (13) to play the first 10 seconds of each track on the disc. When
the desired track is reached, press SCN again to end the scan and play the selected track.
Repeat (RPT)
Press RPT (14) during disc play to continuously repeat the track. Press RPT again to stop
repeating.
Random (RDM)
Press RDM (15) during disc play to play all tracks on a CD in random, shuffled order. Press
RDM again to stop random play.
Display CD Text
Press AS/PS (21) to display any text encoded on the CD (song title, artist, etc.).
CD Player Error Codes
If a problem should develop while operating the CD player, an error code (ER-1, ER-2, etc.)
may appear on the display panel. This can indicate a number of problems with the unit,
including a mechanical error or an error in the microprocessor control of the player. If an error
code should appear, try ejecting and reloading the disc into the player. While the disc is out of
the unit, make sure it is clean and undamaged, and then load it correctly. If this does not solve
the problem, pressing the reset button may help, but will erase the time and preset memory. If
the suggested measures do not solve the problem, contact an approved warranty station near
you for further assistance.