JVC FR-DS100 - Manual (Page 4)

4
Unpacking
Check that the following items were supplied with the FR-DS100.
WorldSpace (WS) antenna (1)
AC power cord (1)
Plug adapter (1)
WS specified extension cable (1)
ID number sticker sheet (1) *
* The 16-digit ID number is not the serial number. The ID number is necessary when subscribing to
WorldSpace broadcaster services. Using the ID number stickers, keep the ID number of your unit in safe
locations where it can be easily found or referred to if necessary. (Refer to page 16.)
Power Supply
A. Operation on AC power
1. When the FR-DS100 is used in an area where the
supply voltage is different from the preset
voltage, set the voltage selector to the correct
position. For more information, refer to “To set
the voltage selector” below.
2. Insert the AC power cord firmly and completely
into the AC IN jack on the unit.
CAUTIONS:
1. ONLY USE WITH JVC POWER CORD PROVIDED
WITH THIS UNIT TO AVOID MALFUNCTION OR
DAMAGE TO THE UNIT. REMOVE BATTERIES
WHEN USING THE POWER CORD.
2. BE SURE TO UNPLUG THE POWER CORD FROM
THE OUTLET WHEN GOING OUT OR WHEN THE
UNIT IS NOT IN USE FOR AN EXTENDED PERIOD
OF TIME.
To set the voltage selector
Before attempting to use this unit, check the voltage
selector on the rear panel of this unit to determine if
the selected voltage is appropriate for the power
supply in your area. If you need to change the setting
to match your local power supply, use a screwdriver
to turn the arrow mark until it is pointed at the
appropriate voltage setting.
B. Operation on batteries
Loading batteries
1. Open the battery cover by pulling it toward you
while pressing down on the tabs marked by the
arrows.
2. Insert 6 “D” size/R 20 batteries as shown in the
diagram below. A similar diagram can also be
found on the rear panel of the unit.
* Be careful to insert the batteries with the ª
and · terminals oriented correctly.
3. Replace the cover.
Removing batteries
1. Open the battery cover as indicated above.
2. Remove the center battery by hooking your finger
onto the cusp of the ª side of the battery, and
pulling outward. The other batteries should then
be easily removable.
3. Repeat step 2 with the other row of batteries.
CAUTIONS WHEN USING BATTERIES:
When batteries are used incorrectly, it may result in
the leakage of chemicals from the batteries or they
may explode. If chemicals from the batteries come in
contact with your skin, wash them off immediately
with water. If chemicals leak onto the unit, clean the
unit completely.
The following care should be taken;
• Check that the positive ª and negative · terminals of the
batteries are oriented correctly and load them as shown in
the diagram.
• Do not mix old and new batteries together, or mix
different types of batteries.
• Do not try to recharge non-rechargeable batteries.
• Remove the batteries when the unit is not to be used for
an extended period of time.
VOLTAGE
SELECTOR
230V
127V
110V
AC IN
SEE BOTTOM
VOLTAGE
SELECTOR
R LINE
ANTENNA
WARNING
• DO NOT PUT BATTERY IN BACKWARDS, MIX WITH
USED OR OTHER BATTERY TYPES-MAY EXPLODE
OR LEAK AND CAUSE PERSONAL INJURY.
• REMOVE THE BATTERIES ("D" SIZE, R20) WHEN
USING THE AC POWER.
• SEE INSTRUCTION MANUAL.
EXTERNAL
L OUT
230V 127V
110V
2 3 1 4 6 5 1.5Vx6
EXTERNAL
2
3 1 4 6 5
1.5Vx6
4
5
6
=
EXTERNAL
2
3 1 4 6 5
1.5Vx6
WARNING • DO NOT PUT BATTERY IN BACKWARDS, MIX WITH
USED OR OTHER BATTERY TYPES-MAY EXPLODE
OR LEAK AND CAUSE PERSONAL INJURY.
• REMOVE THE BATTERIES ("D" SIZE, R20) WHEN
USING THE AC POWER.
• SEE INSTRUCTION MANUAL.
EXTERNAL
2 3 1 4 6
5
1.5Vx6
3
2
1
FR-DS100.02-08 5/6/99, 9:33 AM 4