JVC HR-XVC17SU - Manual (Page 17)

17
Preparation
DISPLAY
TV Aspect
4:3 : Select when a standard 4:3 TV is connected.
16:9 : Select when a 16:9 wide TV is connected.
Display Mode
Display Mode setting works only when the TV Aspect
mode is set to “4:3”.
Letterbox: Displays a wide picture with bands on the
upper and lower portions of the screen.
Panscan: Automatically displays the wide picture on
the entire screen and cuts off the portions that do not
fit.
Progressive Scan
Progressive Scan Video provides the highest quality
pictures with less flickering.
If you are using the Component Video jacks for
connection to a TV or monitor that is compatible with
a progressive scan signal, set Progressive Scan to
On.
To turn on progressive scan:
Connect component/progressive out of this unit to the
input of your monitor/television, set your television or
monitor to component/progressive Input.
1. Select “Progressive Scan” on the DISPLAY menu
then press B.
2. Select “On” using the v / V buttons.
3. Press ENTER / OK to confirm your selection.
The confirm menu will appear.
4. When the confirm menu appears on your screen
“Cancel” is highlighted as default. Use the b
button to highlight “Enter”.
5. Pressing ENTER / OK will set this unit to
progressive scan mode.
Notes:
• If you set Progressive Scan to ON in error, you must
reset the DVD+VCR. Press STOP (
x ) and hold it for
more than five seconds before releasing it. The video
output will be restored to the standard setting, and a
picture will once again be visible on a conventional
analog TV or monitor.
• Do not turn off this DVD+VCR while the
“PROGRESSIVE SCAN MODE” message is displayed
in the TV screen.
DVD
DVD
DVD
DISPLAY
TV Aspect
Letterbox
4 : 3
Display Mode
Off Progressive Scan
Move Select