Jensen CR560X - Manual (Page 9)

9
®
CR560X
Test Speaker Connections
These tests make sure the speakers are connected right. If speakers don’t play at all, both wires
may not be connected. If the wrong speaker plays (you hear front speakers when you expect rear
speakers) make sure you connected the wires right.
Balance
Once everything is operating correctly, perform Final Installation on page 10.
Fader
1. Press SEL four times.
2. Hold the + button until
the display shows
BA.r 10.
Only the right speakers
should be playing.
If not, check the wiring.
Make sure you connected
the wires just like the chart
on page 6.
5. Press SEL five times.
6. Hold the + button until
the display shows
FA.F 10.
Only the front speakers
should be playing.
If not, check the wiring.
Make sure you connected
the wires just like the chart
on page 6.
3. Press SEL four times
again.
4. Hold the – button until
the display shows
BA.L 10.
Only the left speakers
should be playing.
If not, check the wiring.
Make sure you connected
the wires just like the chart
on page 6.
7. Press SEL five times
again.
8. Hold the – button until
the display shows
FA.r 10.
Only the rear speakers
should be playing.
If not, check the wiring.
Make sure you connected
the wires just like the chart
on page 6.
SEL
SEL
SEL
SEL
VOL +
VOL –
SEL
SEL
SEL
SEL
2
3
4
1 SEL
SEL
SEL
SEL
SEL
VOL +
VOL –
SEL
SEL
SEL
SEL
SEL
6
7
8
5
5588 CR560X_EIN.p65 2/29/00, 10:46 PM 9