John Deere OMPC20964 - Manual (Page 142)

Troubleshooting and Diagnostics
OUO6050,0002236 –19–25NOV06–3/5
Control Unit Add. Description Details
iTC 035 DISPLAY/MODIFY: Distance from pivot point of Shown in cm.
vehicle to center of receiver. Range -508 to +508
iTC 036 DISPLAY/MODIFY: Direction that receiver faces 0 = Backward
during normal operation 1 = Forward
iTC 037 DISPLAY/MODIFY: RTK search algorithm status 0 = Off
1 = vehicle
2 = vehicle/repeater
3 = base station (quick survey)
4 = base station (absolute base)
iTC 038 DISPLAY/MODIFY: Current StarFire corrections 0 = differential corrections turned off
being used. 1 = SF1 mode
2 = SF2 mode
iTC 039 DISPLAY/MODIFY: Frequency that StarFire Shown in kilohertz
corrections are received on. 1525000
1560000
iTC 040 DISPLAY/MODIFY: Status of WAAS/EGNOS 0 = WAAS/EGNOS differential corrections are not
correction signal being used.
1 = WAAS/EGNOS differential corrections are being
used.
iTC 041 DISPLAY/MODIFY: Serial port transmission rate. Shown as RS232 baud rate.
4800
9600
19200
38400
iTC 042 DISPLAY/MODIFY: Serial port message frequency. Shown in Hertz.
1 or 5
iTC 043 DISPLAY/MODIFY: GGA Output Status 0 = Off
1 = On
iTC 44 DISPLAY/MODIFY: GSA Output Status 0 = Off
1 = On
iTC 045 DISPLAY/MODIFY: RMC Output Status 0 = Off
1 = On
iTC 046 DISPLAY/MODIFY: VTG Output Status 0 = Off
1 = On
iTC 047 DISPLAY: ZDA Output Status 0 = Off
1 = On
iTC 048 DISPLAY: Output of TCM accelerometer raw signal. Shown in per cent
iTC 049 DISPLAY: Output of TCM accelerometer Shown as one thousandth of acceleration due to
gravity
iTC 053 DISPLAY: Operating temperature of TCM Shown in degrees Centigrade
accelerometer component.
iTC 054 DISPLAY: Latitude as calculated by receiver Shown in degrees
iTC 055 DISPLAY: Longitude as calculated by receiver Shown in degrees
iTC 057 DISPLAY: Course as calculated by GPS receiver. Shown in degrees
iTC 058 DISPLAY: Calibration value of TCM unit on flat
surface.
40-6
121907
PN=142
Continued on next page