John Lewis JLBIDOS904 - Manual (Page 26)

26
)
Cleaning the Oven
Before cleaning always allow the appliance to cool
down before switching off at the electricity supply.
This appliance cannot be cleaned with steam or with
a steam cleaning machine.
The oven should be kept clean at all times. A build
up of fats or other foodstuffs could result in a fire,
especially in the grill pan.
Cleaning Materials
Before using any cleaning materials on your
appliance, check that they are suitable and that their
use is recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Harsh abrasives
and scourers should also be avoided as damage will
occur.
External Cleaning
Do not use abrasive cleaning materials e.g. Hob
Brite, Brillo pads or scourers on painted or printed
finishes as damage may occur.
Regularly wipe over the control panel, doors and
handles using a soft cloth and hot soapy water. To
prevent streaking finish with a soft cloth.
Stainless Steel cream cleaners are abrasive and
should be avoided as they may dull the surface finish.
Any spillage on the stainless steel finish must
be wiped off immediately.
Do not attempt to remove any of the
control knobs from the panel as this
may cause damage and is a safety
hazard.
How to Remove and Replace
the Wirework Runners
1.
Remove all shelves and furniture from the oven.
2. Hold the wirework at the bottom, unclip from
the cavity side and gently pull towards the
centre of the oven.
3. Unhook the runner at the top and remove from
the cavity.
4. To replace the runners, hook the wirework side
runner into the cavity, slide back and press into
place.
Ensure the wirework runners are firmly in
position before replacing the oven
shelves.
CAVITY
CENTRE
SIDE PANEL