Jet Tools DC-1100CK - Manual (Page 12)

12
Canister Kit Assembly
If you purchased Model DC-1100CK Dust Collector,
this section describes the assembly and installation of
the contents of the Canister Kit (SN 708639B).
Canister Filter
1. Mount the handle onto the canister filter with two
M10 hex nuts, two M10 flat washers, and a M10
lock washer (Figure 9).
2. Mount the canister filter on top of the collector
housing (A, Fig. 5) and tighten the knobs on the
canister filter (Figure 9).
Collector Bag
3. Place the snap ring over the top of the plastic bag
and fold the bag over the ring approximately three
inches, as shown in Figure 10.
4. Insert the snap ring (A, Figure 11) of the collector
bag into the bottom of the housing at an angle.
5. Pull down on the snap ring to make sure it seats in
the housing.
Note: Make sure the snap ring “snaps” into place
in the housing, and also that the plastic bag hangs
down approximately 3 inches so that there are no
air leaks.
Figure 9
Figure 10
Figure 11