Jensen Tools JCD2006 - Manual (Page 6)

JCD2006
6
BASIC OPERATION
Control Panel Release ( )
Press the release button (8) to release the control panel. (See “Detachable Control
Panel (DCP)” on page 4.)
Power On/Off ( )
Press the button (1) to turn the unit ON or OFF.
Volume Control
To increase the volume, rotate the volume control knob (12) clockwise.
To decrease the volume, rotate the volume control knob counter clockwise.
Mute
Press the MUTE button (11) to mute the audio output. Press MUTE again to restore the audio
output to the previous level.
Mode
Press the MODE button (6) to select a different mode of operation, as indicated on the display
panel. Available modes include Radio, CDP, and AUX In (optional Auxiliary Input).
Auxiliary Input
With an separately purchased 3.5mm Audio In cable, you can connect your portable CD
player, game player, camera, iPod, etc. to this unit.
1. Connect the external signal to the “Aux In” jack (19) located on the front of the control
panel.
2. Press the MODE
button to select Aux In mode.
3. Press MODE again to cancel
Display (DISP)
Press the DISP button (10) to view the clock. The LCD will display the clock for 5 seconds and
then return to the previous display mode.
Clock Adjustment
With the clock displayed, press the DISP button (10) until the LCD flashes. Press the TUNE up
>>| (7) button to adjust the minutes or the down TUNE |<< button to adjust the hour.
Reset
After releasing the control panel, use a pencil or any non-metallic
object to press and hold the RESET button for five seconds to
reset the main unit. The unit will return to the factory default
settings. The reset button should be activated for the following
reasons:
• initial installation of the unit when all wiring is completed
• function buttons do not operate
• error symbol on the display
NOTE: If after pressing the RESET button the unit still does not function normally, use a
cotton swab soaked in isopropyl alcohol to clean the socket on the back of the control
panel.
Audio Menu
Press the volume control button (5) to access the Audio Menu. You can navigate through the
Audio Menu items by pressing the volume control button repeatedly. Once the desired menu
item appears on the display, adjust that option by turning the volume control knob within 5
seconds. The unit will automatically exit the Audio Menu after five seconds of inactivity. The
following menu items can be adjusted.
Volume Level
Use the volume control knob to adjust the Volume level from “00” (lowest) to “46” (highest).
Bass Level
Use the volume control knob to adjust the Bass level range from “-7” to “+7”.
Treble Level
Use the volume control knob to adjust the Treble level range from “-7” to “+7”.
Balance
Use the volume control knob to adjust the Balance between the right and left speakers from
“R15” (full right) to “L15” (full left). “C00” represents an equal balance between the right and left
speakers.
Fader
Use the volume control knob to adjust the Fader between the front and rear speakers from
“R15” (full rear) to “F15” (full front). “C00” represents an equal balance between the front and
rear speakers.
CD PLAYER / RECEIVER
JCD2006 40 WATTS X 4 AS PS
RDM CH
CD-I N
RPT INT
13 14 15 16 17 18 19
RESET BUTTON
3.5mm Audio In Cable (not included)
Right Audio
Left Audio
Ground
1
2
3
For
Aux In mode and return to previous mode.