Jack Lananne's Power Juicer PPJJEE VV22 - Manual (Page 11)

Juice Spout
Pulp
Collector
Base
Receptacle
6
ASSEMBLY
STEP 2:
Align grooves on the bottom of pulp collector
with tracks on the base. Note: This is where
the Safety MicroSwitch is located.
Slide
pulp collector towards base in the directions
of the arrows. Make
sure pulp collector
is firmly in place
against the base.
IMPORTANT:
The motor will not run
if pulp collector is not
properly assembled.
STEP 3:
Place receptacle on the base, with juicer
spout facing direction of locking bar.
Settle receptacle into alignment.
2
3
1
Assemble as shown
Locking
Bar
Locking
Bar
Front of Machine
(Spout side)
Base
Base
Base
Base (Tracks)
Safety MicroSwitch
STEP 1:
Place base on a dry flat surface with locking
bar in down position as shown. In front
of the machine (spout side).
IMPORTANT:
There is a safety MicroSwitch
located in the track of the left side of the
Machine (opposite side of power switch).
This mechanism is an added
safety feature. Once the pulp
collector is in place it activates
the safety MicroSwitch. This will
protect you from accidentally
putting hands or fingers under
the machine while the blade is
turning. Once the pulp collector
is removed from the main base
the motor will not run.
Pulp Collector
(Bottom)