JVC I'Art Pro LCT1885-001A-A - Manual (Page 71)

71
Troubleshooting
There is no power
There is no picture
or sound
You cannot select a
certain channel
The power turns off
by itself
The clock is wrong
The color quality
is poor
There are lines
across the picture
The picture is spotted
There are double
pictures (ghosts)
Picture is snowy
(image noise)
Screen is 40% black
Stereo or bilingual
programs can't be
heard
Static electricity
You hear occasional
crackling sounds
Remote control is not
operating properly or
at all
• See if the power cord became unplugged.
• Check for a blown fuse or circuit breaker or a power outage.
• The antenna could be disconnected.
• The input mode could be set improperly. See page 50.
• The tuner (Auto Tuner Setup) could be set improperly. See page 33.
• The TV station may be having difficulties. Check to see if other stations are working.
• Check to see that the batteries are still working and properly installed.
• Make sure the remote has a clear sight path to the TV.
• Check that the TV/CATV switch is in the proper position.
• You may be too far from the TV. You must be within 23 feet (7 meters).
• Make sure the channels have been programmed. See "Channel Summary", page 34.
• Check to see if the channel is locked. See "Channel Summary - Lock" page 35.
• Make sure the set did not become unplugged.
• Perhaps the On/Off Timer is set. See page 57.
• Check to see if the Sleep Timer was set. See page 61.
• The power was interrupted and the clock was not reset. See page 56.
• Tint and Color may be improperly adjusted. See page 53.
• The Video Status mode may be turned to the wrong setting. See page 67.
• There could be interference from another electrical appliance, such as a computer,
another TV or VCR. Move any such appliances further away from the TV.
• There could be interference from a high-wattage appliance, like a hairdryer or vacuum,
operating nearby. Move the antenna away from the appliance or change to a coaxial
cable connection which is less prone to interference.
• A building or passing airplane can reflect the original signal and produce a second,
slightly delayed one. Adjust your antenna position.
• Your antenna may be damaged, disconnected or turned. Check the antenna
connection. If the antenna is damaged, replace it.
• The Closed Caption Text mode is on. Turn it off in the Closed Caption Menu, page 46.
• Make sure the MTS settings are correct. See page 61.
• It is normal to feel static electricity if you brush or touch the screen.
• It is normal for the TV to make crackling sounds when first turned on or off. Unless
the sound or picture become abnormal, this is fine.
PROBLEMS CHECK
The square appears
and blinking • It appears when you are operating the Auto Convergence. If not, then this may
be a problem with the Auto Convergence. Contact a service agent.
It does not operate
correctly • Press the CHANNEL- and VOLUME- buttons on the front panel of the TV simultaneously
for a few seconds. The Digital Tuner will be reset. If this does not reset it correctly, unplug
the power cord and plug it back in.
LCT1885-001A-A ENG 71 7/20/05, 9:08:10 AM