Jensen HD Radio JiMS-525i - Manual (Page 18)

- 17 -
USING HEADPHONES (NOT INCLUDED)
Inserting the plug of your headphones (not included) into the Headphone jack, on the back of the Radio,
will enable you to listen in private. When using headphones, the speakers will be disconnected
automatically.
NOTE: READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES
1. Avoid extended play at very high volume as it may impair your hearing.
2. If you experience ringing in your ears, reduce the volume or shut off your unit.
3. Keep the volume at a reasonable level even if your headset is an open-air type designed to allow you
to hear outside sounds. Please note that excessively high volume may still block outside sounds.
CLOCK SETTING
The following procedures can be accomplished by using either the remote or the controls on the main
unit.
Setting the Time
The Clock can only be set in POWER off mode.
1. Press and hold the SET Button for 2 seconds and the Hour digits of the clock will flash.
2. Press the or Buttons until the correct Hour digits appear in the LCD.
Note: Make sure the hour is set so that AM or PM is correctly displayed. It is important that the "AM" or
"PM" setting is correct for proper operation of the Alarm function.
3. Press the SET Button to confirm. Minute digits will appear and flash in the LCD.
4. Press the or Buttons to set the Minute digits.
5. Press the SET Button to exit and activate the new clock time to operate.
JENSEN JIMS-525i_Eng ib_Rev.p65 5/15/2008, 5:51 PM 17