Jet Tools J-3410-2 User Manual
7x12 cut-off band saw, Operating instructions and parts manual
Advertising
Operating Instructions and Parts Manual
7x12 Cut-off Band Saw
Models: J-3410, J-3410-2
WALTER MEIER (Manufacturing), Inc.
427 New Sanford Road
LaVergne, Tennessee 37086
Part No. M-414454
Ph.: 800-274-6848
Revision B1 03/2012
www.waltermeier.com
Copyright © 2012 Walter Meier (Manufacturing), Inc.
This .pdf document is bookmarked
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- J-3410 Band Saw
- Warranty and Service
- Table of Contents
- General Specifications
- Warning
- Operating Instructions
- Using the vise
- Locking vise jaw
- Changing the locking jaw location
- Stationary vise jaw
- Changing the stationary vise jaw position
- Adjusting stationary jaw: straight cuts
- Adjusting stationary jaw: angle cuts
- Adjusting angles with the scale on the saw table
- Adjusting stationary jaw for high accuracy angle cutting
- Setting the blade guides
- Controlling the cut: Hydraulic feed control
- Using the stock stop for repeated cuts
- Changing blade speeds
- Blade selection
- Evaluating cutting efficiency
- Blade break-in procedures
- Starting a cut
- Right angle cuts -- single pieces of stock
- Angle cutting
- Maintenance
- Replacing blades
- Adjusting blade tracking
- Blade alignment adjustments
- When to adjust the blade guides
- Replacing blade guide and support components
- Adjusting blade vertical
- Test cutting to verify adjustment accuracy
- Adjusting guide bearings
- Replacing guide bearings
- Adjusting blade back-up bearings
- Replacing the drive wheel
- Installing the vertical sawing table
- Replacing idler wheel or bearings
- Servicing the hydraulic control cylinder
- Machine Set-up
- Troubleshooting
- Replacement Parts