JVC HR-XVC29SU - Manual (Page 62)

Filename [XVC2829US_10Subsidiary.fm]
Masterpage:Left+
62
EN
Page 62 8 December 2004 10:32 am
SUBSIDIARY SETTINGS (cont.)
Picture Settings
* The default setting is bold in the table below.
Audio Settings
* The default setting is bold in the table below.
8 MONITOR TYPE
16:9
4:3 LB
4:3 PS
You can select the monitor type depending the TV used when you play back
DVD VIDEO discs recorded for wide-screen TVs. For more details, refer to
“Monitor Set (DVD deck)” (
੬
pg. 17)
8 PICTURE SOURCE
AUTO
FILM
VIDEO
You can obtain optimal picture quality by selecting whether the content on the
disc is processed by field (video source) or by frame (film source).
Normally set to “AUTO.”
AUTO : Used to play back a disc containing both video and film
source materials. This unit recognizes the picture type (film or
video source) of the current disc according to the disc
information.
FILM : Suitable for playing back a film or progressive source disc.
VIDEO : Suitable for playing back a video source disc with relatively a
few moments.
● If the playback picture is unclear or noisy, or the oblique lines of the picture
are rough, try to change to other modes.
8 SCREEN SAVER
ON
OFF
The TV screen may be burned out if a static picture is displayed for a long time.
When this function is set to “ON,” the unit automatically activates the screen
saver function if a static picture, such as an on-screen display or menu is
displayed for over 5 minutes.
8 DIGITAL AUDIO OUTPUT
PCM ONLY
DOLBY DIGITAL/PCM
STREAM/PCM
Set to the appropriate mode according to the type of the device connected to
DIGITAL AUDIO OUT connector on the rear of unit.
Set this item correctly according to the logo on the device.
It is not necessary to set this mode when you connect no device to DIGITAL
AUDIO OUT connector.
PCM ONLY :
Select this when connecting to a device bearing neither Dolby
Digital nor DTS logo, or a digital recorder.
DOLBY DIGITAL/PCM :
Select this when connecting an amplifier or a decoder bearing
Dolby Digital (without DTS) logo.
STREAM/PCM :
Select this when connecting an amplifier or a decoder bearing both
Dolby Digital and DTS logos.
8 DOWN MIX
DOLBY SURROUND
STEREO
Set to the appropriate mode according to your audio system when you play
back a DVD VIDEO disc recorded with surround multichannel audio. This
setting affects only the analog audio output signal from the AUDIO OUTPUT
connectors (DVD) when playing back a DVD VIDEO disc recorded with
surround multichannel audio.
DOLBY SURROUND :
Select this when you enjoy multichannel surround audio by
connecting the unit’s analog AUDIO OUTPUT connector
(DVD) to a surround decoder.
STEREO : Select this when you enjoy conventional 2-channel stereo
audio by connecting the unit’s analog AUDIO OUTPUT
connectors (DVD) to a stereo amplifier/receiver or TV, or when
you dub audio of a DVD VIDEO disc recorded with surround
audio to your MD, cassette, etc.
XVC2829US_01.book Page 62 Wednesday, December 8, 2004 10:48 AM