JVC UX-G1 - Manual (Page 10)

7
To connect AM (MW) and FM antennas
1 Attach the FM antenna to the FM COAXIAL
75
Ω terminal.
Fasten it up in the position which gives you the best
reception, then fix it on the wall, etc.
2 Connect the supplied AM (MW) loop
antenna to the AM LOOP terminal.
Place the antenna away from the unit and adjust its
position for the best reception.
For better reception of both FM and AM (MW)
• Make sure the antenna conductors do not touch any other
terminals or connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
AM
LOOP
FM 75
Ω COAXIAL
AM (MW) loop antenna
(supplied)
IMPORTANT:
Be sure to check that all connections have been made
before plugging in the power cord.
FM antenna
NOW you are ready to plug in the unit.
2
1
About the supplied FM antenna
The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outdoor FM
antenna.
To connect an outdoor FM antenna
Before connecting the antenna, disconnect the supplied FM
antenna.
Outdoor FM antenna
(not supplied)
A 75 Ω antenna with coaxial type connector
(IEC or DIN 45325) should be used.
Coaxial cable (not supplied)
AM
LOOP
FM 75
Ω COAXIAL
UX-G1[B]_rev_04connect_f.p65 05.1.28, 11:28 AM 7