JVC UX-G1 - Manual (Page 14)

11
Presetting Stations
You can preset 30 FM and 10 AM (MW) stations manually.
In some cases, test frequencies have been already stored
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You
can preset the stations you want into memory by following
the presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start again from step 2.
On the remote control ONLY:
1
Tune in to the station you want to preset.
• See “Tuning in to a Station” on page 10.
2
Press PROGRAM.
The PRGM (program) indicator and “00” start
flashing on the display.
3
Press or to select a preset
number.
4
Press PROGRAM again.
The PRGM indicator and the selected preset
number stop flashing.
5
To preset more stations, repeat steps 1 to 4
above, allocating a different preset number to
each station.
PROGRAM
• Storing a new station on an already assigned number erases
the previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will remain in the unit.
PROGRAM
Tuning in to a Preset Station
On the remote control ONLY:
1
Press TUNER/BAND to select either
“FM” or “AM.”
The unit automatically turns on and tunes in to
the previously received station—either FM or
AM (MW).
• Each time you press the button, the band alternates
between FM and AM (MW).
2
Press or to select a preset
number.
TUNER/
BAND
UX-G1[B]_rev_06tuner_f.p65 05.1.28, 11:28 AM 11