Jettech Metal Products X-32 - Manual (Page 3)

Warranty
MANUFACTURERS LIMITED WARRANTY
Jet Tech Systems Corporation (Jet Tech) hereby warrants all new warewashers bearing the name “JET TECH” and installed
within the continental United States of America or Canada to be free from defects in material and workmanship, under
normal and regular usage and operation, for a period of one (1) year following the date of original installation, (unless
specified otherwise) but in no event can exceed eighteen (18) months from the date of shipment from the factory.
If a defect in material(s) or workmanship is detected; or found to exist within the stated period above, Jet Tech, at its sole
discretion, shall either repair or replace any original equipment manufacturers part which has proven to fail within the
machine; providing that the equipment has not been altered or tampered with in any manner, has been installed correctly as
per the owners manual, and maintained and operated in complete accordance with this manual.
The labor cost to repair or replace any part proven to be defective, as per above clause(s), shall be covered by Jet Tech
Systems, within the continental United States of America or Canada; provided that: prior authorization for this labor was
approved by Jet-Tech Systems, the service work was performed by an authorized Jet Tech service agency; and that this
agency installed an original and genuine Jet Tech part in the machine. Any repair work performed by a non-authorized
service depot remains the sole responsibility of the user, and Jet Tech Systems will not be held responsible. The installation
of any generic part will not be valid; and therefore voids this warranty. All authorized labor coverage shall be limited to
regular hourly rates only. Any supplemental hourly rates or charges, such as weekends or emergency premiums remain the
responsibility of the user.
Jet Tech Systems Corp. (Jet Tech) hereby states that: warranty travel time shall be limited to, and without exception, a round-
trip total of two (2) hours OR mileage up to a maximum of one hundred (100) miles round-trip. Any charges exceeding those
stated herein must have prior authorization by the factory.
Exceptions to above warranty are: (A) Damages resulting from shipping, handling or abuse. (B) Incorrect installation and/or
connections. (C) Adjustments or calibration of any parts. (D) Faults due to lack of regular maintenance or cleaning of any
internal part(s). (E) Replacement of any wearable items such as: glasswasher curtains, or peristaltic squeeze tubing or
gaskets. (F) Excessive lime, mineral, alkali or hard water conditions (In excess of 6 grain) and (G) Poor results due to: use of
an incorrect type of detergent (for non-commercial type applications), and excessive or inadequate water temperature(s) or
pressure conditions or incorrect use. (H) Labour and mileage coverage does not apply upon condition of sale.
JET TECH SYSTEMS CORPORATION STATES THAT THERE ARE NO OTHER WARRANTIES, EXPRESSED OR
IMPLIED, THAT ARE NOT SET FORTH HEREIN, JET TECH SYSTEMS CORPORATION SHALL ASSUME NO
OTHER RESPONSIBILITY, EITHER DIRECT OR NON-DIRECT, OR BE LIABLE FOR ANY OTHER OR
ADDITIONAL LOSS OR DAMAGE WHETHER BEING DIRECT OR CONSEQUENTIAL, AS A RESULT OF ITS
EQUIPMENT.
Warranty:
One year parts & labor (Continental USA and Canada).
Exceptions: Model “F14” - 90 days labor & One year parts.
The manufacturer reserves the rights to alter design and specifications without notice.
3