JVC 0504CSH-ID-VT - Manual (Page 75)

Masterpage:Right-No-Heading
EN
75
Filename [XV3EX_10Subsidiary.fm]
Page 75 August 22, 2003 12:20 pm
NOTES:
● Just Clock (when set to “ON”) adjusts the unit’s built-in clock
every hour, except for 23:00, 0:00, 1:00 and 2:00.
● Just Clock is not effective when:
— the unit’s power is on.
— the unit is in the Timer mode. (VHS deck only)
— a difference of more than 3 minutes exists between the
built-in clock’s time and the actual time.
— the unit is in the Automatic Satellite Programme Recording
mode. (
੬
pg. 28) (VHS deck only)
— the unit is in the Power Save mode. (
੬
pg. 64) (VHS deck
only)
— “L-2 SELECT” is set to “SAT”. (
੬
pg. 64) (VHS deck only)
● If Just Clock is set to “ON”, the unit’s clock is automatically
adjusted at the start/end of Summer Time.
● Just Clock may not function properly depending on the
reception condition.
Child Lock
You can disable the unit’s operation.
A
Set the Child Lock.
Press and hold 1 on the remote control for more than
10 seconds while the unit is turned on. The unit turns off,
and “CL“ appears on the front display panel.
● To release the child lock, press and hold
1 on the remote
control until the unit turns on.
NOTES:
● When the child lock function is in use, keep the remote
control out of the children’s reach.
● Timer recording programmes will be performed even if the
child lock function activated.
Just Clock
The Just Clock function provides accurate time keeping
through automatic adjustments at regular intervals, by
reading data from a PDC signal.
The Just Clock option can be set “ON” or “OFF” at the Clock
Set screen (the default setting is “OFF”). Press OK until the
Just Clock setting begins blinking, then press rt to change
the setting.
IMPORTANT: If you turn off Just Clock, the accuracy of your
unit’s built-in clock may be reduced, which could adversely
effect timer recording. We recommend you to keep Just
Clock on. In cases where the clock setting data from a PDC
signal is incorrect, however, you are advised to keep Just
Clock set to “OFF”.
● Turn on the TV and select the video channel (or AV
mode).
● Slide the TV/VCR/DVD switch to the right.
XV3EX_01.book Page 75 Friday, August 22, 2003 12:21 PM