JVC GR-DVL105 - Manual (Page 59)

EN
59
Indications Function
Appears if condensation occurs. When this indication is displayed, wait
more than 1 hour until condensation disappears.
Appears if a tape is not loaded when the Recording Start/Stop Button or
SNAPSHOT Button is pressed while the Power Switch is set to “
” or
“ ”.
Appears when the tape ends during recording or playback. (
੬
pg. 13)
Appears if a tape in another format is loaded.
● Appears when the date/time is not set.
(
੬
pg. 9)
● Appears when the built-in clock battery runs out and the
previously set date/time is erased. Consult your nearest JVC dealer
for replacement.
Appears for 5 seconds after power is turned on if the lens cap is attached.
Appears if Audio Dubbing is attempted on a blank portion of a tape.
(
੬
pg. 49)
● Appears if Audio Dubbing is attempted on a tape recorded in the LP
mode. (
੬
pg. 49)
● Appears if Audio Dubbing is attempted on a tape recorded in 16-bit
audio. (
੬
pg. 49)
● Appears if A. DUB (e) on the remote control is pressed when the erase
protection tab is set to “SAVE”. (
੬
pg. 49)
Appears if dubbing of copyguarded signals is attempted while this
camcorder is being used as a recorder.
The error indications (E01 — E06) show what type of malfunction has
occured. When an error indication appears, the camcorder turns off
automatically. Remove the power supply (battery, etc.) and wait a few
minutes for the indication to clear. When it does, you can resume using the
camcorder. If the indication remains, consult your nearest JVC dealer.
SET DATE/TIME!
COPYING FAILED
E01 — E06
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY
A. DUB ERROR!
<CANNOT DUB
ON AN LP RECORDED
TAPE>
<CANNOT DUB
ON A 16BIT
RECORDING>
<CHECK TAPE’S ERASE
PROTECTION SWITCH>
A. DUB ERROR!
TAPE!
TAPE END
DIFFERENT
FORMATTED TAPE
LENS CAP
CONDENSATION,
OPERATION PAUSED
PLEASE WAIT