JVC GM-P421U - Manual (Page 24)

22
P I C T U R E A D J .
S I Z E / P O S I T I O N A D J .
F U N C T I O N S E L E C T
S T A T U S D I S P L A Y
E N T E R :
M A I N M E N U
S E L E C T : E X I T : M E N U
Cursor ( 3 )
Video Adjustments
(Continued)
MENU INPUT POWER
MENU INPUT POWER
MENU 2 / 3
5
5 /
C O L O R T E M P .
P I C T U R E M O D E
A S P E C T
S I G N A L M O D E
R G B / C O M P O .
r e s e t
F U N C T I O N S E L E C T
A D J U S T : S E L E C T : E X I T : M E N U
: H I G H
: S T I L L
: P A N O R A M I C
: A U T O
: C O M P O . *
AUTO 480i 576i
480p 720p 1080i
(1035i)*
Setting the Receivable Signal Types
You can set the receivable signal types. Normally, select
“AUTO.”
A common setting will apply to both the VIDEO A input and
the VIDEO B input, and a different setting will apply to the
COMPONENT input.
1
Press MENU/EXIT (or MENU on the
Monitor) to display the Main Menu.
2
Press 5/∞ to move the cursor (3) to
“FUNCTION SELECT.”
3
Press 3 to display the Function
Selection Menu.
4
Press 5/∞ to move the cursor (3) to
“SIGNAL MODE.”
5
Press 2/3 to select the receivable video
signal type.
Each time you press the button, the receivable video
signal type changes as follows:
• When VIDEO A or VIDEO B input is selected:
• Whe n COMPONENT input is selected:
* Changes according to the “HD SIGNAL MODE”
setting (see page 27).
6
Press MENU/EXIT (or MENU on the
Monitor) twice to exit the menu
operations.
* 2
* 1
* 1 “PICTURE MODE” and “SIGNAL MODE” do not
appear at the same time.
“PICTURE MODE” appears when RGB input (either
RGB A or RGB B) is selected, and one of the following
signals comes in—RGB15K-50, RGB15K-60, and
VGA480-60. On the other hand, “SIGNAL MODE”
appears when VIDEO A, VIDEO B, or COMPONENT
input is selected.
*
2
“RGB/COMPO.” appears only when the RGB B or
COMPONENT input is selected.
MENU/EXIT
2 / 3
5 /
5
DISPLAY ASPECT POWER
RGB A COMPO. VIDEO B VIDEO A
MUTING
MENU/EXIT
RM-C576 REMOTE CONTROL UNIT
VOLUME
RGB B
AUTO NTSC
PAL N PAL M
14-23.GM-P420[US]f 02.4.1, 2:20 PM 22