Jonsered CS 2250S - Manual (Page 40)

40 – English
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for the Jonsered chain saw models CS 2245, CS 2245S and
CS 2250S. The combinations of power head, bar and chain have been tested and found to be in accordance with the
kickback and vibration requirements of ANSI B 175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose
radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.
Bar and chain combinations
Chain saw models Jonsered CS 2245, CS 2245S and CS 2250S met the kickback performance requirements of ANSI
B 175.1-2000 when tested with the combinations of bars and saw chains listed below. The saw chain Jonsered H30 is
also classified as a low kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI B
175.1-2000. We recommend to use only the listed combinations of bars and chains for chain saw models Jonsered
CS 2245, CS 2245S and CS 2250S. Other chain saw models may not meet the kickback requirements when equipped
with the listed bar and chain combinations.
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below.
Bar Chain
Length, inch Pitch, inch
Thickness of drive
links, inch/mm
Max. nose radius Type Drive link count
13 0,325
1,3
10T
Jonsered H30
56
15 0,325 10T 64
16 0,325 10T 66
18 0,325 10T 72
13 0,325
1,5
10T
Jonsered H25
56
15 0,325 10T 64
16 0,325 10T 66
18 0,325 10T 72
20 0,325 12T 80
16 0,325
1,5
10T
Total NT 528PS
66
18 0,325 10T 72
0,050"/1,3 mm H30 - NT 520PS
0,058"/1,5 mm - H25 NT 528PS