JVC XV-SA70BK - Manual (Page 21)

Getting started
19
Ge
ttin
g s
ta
rte
d
English
The unit supports the linear PCM multichannel format of DVD AUDIO and can feed multichannel audio output signals
from the 6 ANALOG AUDIO OUT jacks.
It is also equipped with the DTS and Dolby digital decoders. So you can enjoy any type of the high quality surround
sounds by connecting the unit to an amplifier/receiver equipped with the 5.1-channel inputs.
Connect the unit
' s ANALOG AUDIO OUT jacks to the analog 5.1-channel inputs of an amplifier or receiver using the
supplied audio cables.
• Be sure to connect correctly between corresponding terminals. The order of the 5.1-channel terminals depend on units.
To connect to an amplifier/receiver equipped with 5.1-channel inputs
NOTE
• When using the 5.1-channel outputs of the unit, set the “DOWN MIX” in the “PREFERENCE 2” on-screen display to “OFF” and
select “5.1 CHANNEL” or “EXPERT” in the “SPK.SETTING” on-screen display. If the “EXPERT” is selected, you can control the
audio output balance of the speakers (see pages 57 and 59).
AV COMPU LINK
The unit
Amplifier or receiver
AUDIO IN
RIGHT
FRONT
LEFT
REAR
RIGHT
LEFT
CENTER
SUBWOOFER
Audio/Video
cable
(supplied)
Audio cable
(supplied)
Audio cable
(supplied)
Red
White
White
White
Red
Red
Yellow
Re
d
Re
d
White White White
Y
ellow
Re
d
VIDEO OUT DIGITAL OUT
RIGHT
COMPONENT
S-VIDEO
Y P B P R
PCM / STREAM
COAXIAL OPTICAL
LEFT
VIDEO
FRONT
REAR
RIGHT LEFT SUBWOOFER CENTER
AUDIO OUT
6$(1*ERRN 3DJH  0RQGD\ -XQH     30