Juniper Networks IDP SERIES IDP250 - Manual (Page 43)

NOTE: After you have completed the initial configuration, we recommend
highly that you use ACM to change the default password.
5. Click QuickStart to start the QuickStart wizard. Complete the wizard steps as described
in the online Help.
If you prefer, you can click ACM instead and run the ACM wizard at this point. However,
the ACM wizard entails a lengthier configuration. You might be more comfortable
running the ACM wizard over the network.
Related
Documentation
Performing the Initial Configuration on page 27 •
Getting Started with the ACM Wizard (Management Port)
You use the ACM wizard to complete the appliance configuration.
To get started with the ACM wizard:
1. Run the EasyConfig wizard or QuickStart wizard to assign the management interface
an IP address you can reach from your subnet.
2. Connect one end of a CAT-5 cable to the management interface port and the other
end to the switch or hub (recommended).
3. Verify that the link LED on the management port is green, indicating an active
connection.
4. Return to your desk and open a Web browser.
5. In the browser Address or Location box, enter https:// IP, where IP is the IP address
you assigned to the management interface. For example, if you configured the IP
address 10.100.200.1, enter https://10.100.200.1.
NOTE: ACM access uses SSL, so you must type https:// and not http://.
6. Type the default user name (root) and password (abc123).
7. Click ACM to start the ACM wizard. Complete the wizard steps as described in the
online Help.
Related
Documentation
Performing the Initial Configuration on page 27 •
Installing the Product License Key
IDP OS 4.1 and later releases require you to install a permanent license key.
31 Copyright © 2012, Juniper Networks, Inc.
Chapter 5: Performing the Initial Network Configuration and Licensing Tasks