GE RM24933 - Manual (Page 16)

15
Trouble Shooting
Problem
Indicator light not
blinking when
you press any key
The remote does
not operate your
device
Not performing
commands
properly
Problems
programming
a TV/VCR Combo
Unit
VCR not
recording
Channel up and
down do not
function on an
RCA TV
Problems chang-
ing channels
No response
after pressing
a key
Solution
A) Replace the batteries
(with fresh, new AAA
Alkaline batteries).
B) Check that batteries are
properly installed.
A) Try all the codes listed
for your brand.
B) Try the Code Search
method (page 8).
Start Code Search over again
to locate the proper code.
Try the VCR code for your
brand. Some combo units,
however, may require both
a TV and a VCR code for full
operation.
As a safety feature on your
remote, you must press the
REC button twice.
Due to some designs, the
original remote will only
perform these functions.
If your original remote
required ENTER after a chan-
nel, press ENTER after you
select a channel.
A) Make sure you have
new batteries, and you
are aiming your remote
at your devices.
B) Check that batteries are
properly installed. See
page 2.