Asset recovery pinhole – Juniper Networks NETSCREEN 200 User Manual
Page 10
Chapter 1 Overview
4
User’s Guide
Asset Recovery Pinhole
The Asset Recovery Pinhole is a button that resets the device to its original default
settings. To use this button, insert a stiff wire (such as a straightened paper clip) into the
pinhole.
Alarm
System Alarm
red
Critical alarm:
• Failure of hardware component or software
module (such as a cryptographic algorithm).
• Firewall attacks detected.
• HA status changed
amber
Major alarm:
• Low memory (less than 10% remaining).
• High CPU utilization (more than 90% in use).
• Session full.
• Maximum number of VPN tunnels reached.
• HA redundant group member not found.
off
No alarms.
Status
Session
Utilization
amber
Session utilization is between 70% and 90%.
red
Session utilization is greater than 90%.
off
Normal operation.
Flash
Memory Card
Status
green
The card is installed.
blinking green
Read-write activity is detected.
off
Flash card slot is empty.
Warning:
Because resetting the device restores it to the original default configuration, any
new configuration settings are lost, and the firewall and all VPN service become
inoperative.