Jet Tools DC-1100G - Manual (Page 8)

8
Unpacking
DC-1100C/RC Dust Collector
1. Remove all contents from the shipping carton.
2. Report any damage to your distributor.
3. Do not discard any shipping material until after
the dust collector has been assembled and is
running properly.
Contents of the Shipping Carton
Canister Filter Box
1 – Canister Filter
1 – Handle
1 – Bag of Hardware for Handles
(2) M10 Hex Nuts
(2) M10 Flat Washers
(1) M10 Lock Washer
(4) Knobs
DC-1100C/RC
1 – Base
1 – Housing
1 – Owner's Manual
1 – Warranty Card
1 – Motor/Fan Assembly
5 – Collector Bags
1 – Snap Ring
2 – Ring Clamps
4 – Casters
1 – Inlet Port & Inlet Cap
3 – Support Legs
2 – Hoses
1 – Bag of Assembly Hardware
(16) M8 x 20 Hex Cap Screws
(22) M8 Flat Washers
( 0 8) M6 x 12 Pan Head Flange Bolts
(36) M8 Hex Nuts
Tools Required for Assembly
2 – 13mm Wrenches or Sockets
1 – 14mm Wrench or Socket
1 – #2 Cross Point Screw Driver
1 – 17mm Wrench
Bag of Hardware for Handles
Bag of Assembly Hardware
Read and understand the entire contents of this manual before attempting set-up or
operation! Failure to comply may cause serious injury.