Jensen JTA-450 - Manual (Page 9)

8
IMPORTANT:
Moving or jarring the Turntable without securing the Tone Arm Clamp (6) could result in
damage to the Tone Arm (3).
ENCODING RECORDS TO MP3
You can convert you favorite records into MP3 files and store then on a USB Flash
Drive or SD/MMC Memory Card via the USB port (22) or SD/MMC slot (20) located
on the front panel.
1.
Insert a USB flash drive into the USB PORT (22) or an SD/MMC Memory Card into
the SD/MMC Slot (20) located on the front panel.
2. Press the RECORD Button (17), “REC” and “USB” will begin to flash in the display,
If a USB Flash Drive is inserted. If an SD/MMC Card is inserted then “REC” and
“CARD” will flash in the display. If both USB and SD/MMC card are inserted, then
Icon “SEL” will also appear and flash in the Display.
3. You can use the SKIP + Button (18) or the SKIP - Button (19) to select what media
you want to record to.
4. Select the track to be encoded and start playing the record.
5. Press the Record button to start sync encoding. The following will be displayed
depending on what media you are using to store the music.
Encoding to USB Encoding to Card
6.
To stop encoding press the STOP/USB/SD Button (15).
Note: To ensure the encoding is successful, remove the USB or Card a few
seconds after pressing the STOP Button.
7. To start recording again, press the RECORD Button (17) again and follow step
#2 above.
PLEASE NOTE : If you want to encode an entire side of a record and have seperate
MP3 files for each track, you must manually press the STOP/USB/SD Button (15) at
the end of each track and then press the RECORD Button (17) again to start recording
the next track. If you do not manually Stop and Start the recording process after each
track, you will end up with one large MP3 file that will have all the songs from the side of
the record playing one after the other.