JVC HR-XV10AG - Manual (Page 12)

Connections (Cont’d)
Connecting to Optional Equipment
Connecting to an amplifier equipped with two
channel analog stereo or Dolby Surround
Connect the Left and Right AUDIO OUT jacks on this
unit to the audio left and right in jacks on your amplifier,
receiver or stereo system, using the audio cables.
Connecting to an amplifier equipped with two
channel digital stereo (PCM) or to an Audio/
Video receiver equipped with a multi-channel
decoder (Dolby Digital™, MPEG 2 or DTS)
11
Connect this unit’s DIGITAL AUDIO OUT jack
(COAXIAL) to the corresponding in jack on your
amplifier. Use an optional coaxial audio cable.
22
You will need to activate this unit’s digital output.
(See “Digital Audio Output” on page 16).
Digital Multi-channel sound
A digital multi-channel connection provides the best
sound quality. For this you need a multi-channel
Audio/Video receiver that supports one or more of the
audio formats supported by your unit (MPEG 2, Dolby
Digital and DTS). Check the receiver manual and the
logos on the front of the receiver.
Warning:
Due to the DTS Licensing agreement, the digital output
will be in DTS digital out when DTS audio stream is
selected.
Notes
– If the audio format of the digital output does not match
the capabilities of your receiver, the receiver will
produce a strong, distorted sound or no sound at all.
– To see the audio format of the current DVD in the On-
Screen Display, press A. MONITOR.
12
Amplifier (Receiver)
Both DVD and
VCR out
2 channel analog stereo or Dolby Surround connection.
DVD exclusive out Digital multi-channel
connection
Rear of this unit
L R
AUDIO INPUT DIGITAL INPUT
COAXIAL
AUDIO
VHS
IN
DVD/VHS
OUT
VIDEO
R
L
AUDIO
OUT
VIDEO OUT
R COAXIAL
L
DIGITAL
AUDIO OUT COMPONENT
VIDEO OUT
Pr
Pb
Y
DVD EXCLUSIVE OUT